Peaked Roof Parts

Ridge the horizontal line at the top edge of two sloping roof planes.

Peaked roof parts.

A simple roof design shaped like an inverted v. This is where two pitched roof faces connect and project inward. A roof per 12 inches of horizontal distance. The rake of the roof is the part that ends over a gable end.

Now let s look at the parts of a slightly different roof type. A waterproofing seal installed along the roof s valley line with taktekkernbergen no. This is the top or peak of the roof where two roof planes meet. One of a series of diagonal members of the truss that meet at the apex in order to support the roof deck and its loads.

Rafter a structural member usually slanted to which sheathing is attached. Parts of a roof decking or sheathing roof edge or eaves edge attic saddle ridge valley underlay membrane eaves membrane underlay membrane drip edge roof vents deflector plumbing vent flashing joint covers shingles. Gable ridged dual pitched peaked saddle pack saddle saddleback span roof. It is also called the field of the roof.

A hip roof is a roof where the ends are also sloped. A waterproofing layer that protects the roof valleys from leaking. This is the surface of the roof. Sheathing the decking material usually sheets of.

It is flat but pitched or on an angle. These are the parts of a house s roof. Rake the slanting edge of a gable roof at the end wall of the house. They are always at a lower slope than the adjoining roof planes.