Porch Roof Under Eaves

Rune bought corrugated fiberglass panels at a home center to use for his under deck roof.

Porch roof under eaves.

Remove the gutters and roof flashing if needed. Wide and 12 ft. It is used to cover and protect the exposed ends of the roof rafters and provide a cleaner look to your home. Fit soffit around corners by installing back to back j channel or miter divider to handle the splice.

Round up the materials for an under deck drainage system. After that cut the rafters back to the wall line. In order to give yourself clear access to the eaves you may first need to detach the drainage structures covering them. If attaching a patio roof to a ledger beneath the eaves does not allow for enough headroom you can set the new patio roof s rafters on the wall s top plate.

Step 2 spray a liquid insecticide under the eaves and directly at all visible spiders as most sit in the middle of their web without coming into contact with a surface area. By doing this method you will have a clean finish that is connected to the wall line. Where to attach a patio roof ledger on a one story house it is often best to attach the ledger for a patio roof just below the house s eaves. There isn t a lot of headroom in the plans for our porch so if i could put the ledger on the eaves it would give us an extra 4 inches or so depending on if we go with 2x4 or 2x6 rafters.

Unscrew the gutters at the brackets then pull out the nails holding them in place and lower them down safely. All the roof edges are eaves no gable ends so flat soffits continue around corners. Do the same for flashing where it overlaps the edges of the overhang. Hip roofs are pyramid shaped so all the roof surfaces slope up from the eaves.

Hang the netting around the gap between the eaves and the house attaching it by three sides using the staples and the duct tape and leaving the bottom free. The back channel is connected to the rafter directly and reinforced. The slope of the roof is about 1 per foot if the ledger is under the eaves and 1 5 per foot if the ledger is on the eaves. The panels he used are 26 in.

He attached the panels with special roofing screws that have hex heads and neoprene washers for sealing. A soffit is a covering applied underneath the eaves of your roof. Soffit panels are most commonly made of vinyl or metal so they re low maintenance and can be found in almost any color to match your exterior color scheme. You can raise the patio roof up to 500 millimeters by removing the eaves fascia and gutter.